Next Up Previous Contents Index

3.2 Starting the Installation Program

Starting the Installation Program

Now it's time to start installing Red Hat Linux. To start the installation, it is first necessary to boot the installation program. Before we start, please make sure you have all the resources you'll need for the installation. If you've already read through Chapter 2, and followed the instructions, you should be ready.

[Alpha Systems: If you haven't created your diskettes yet, please read Section D.4, and create them now. After you've created the necessary diskettes, please read Section D.5 for information on starting the installation.]

[SPARC Systems: If you haven't prepared for the installation yet, please read Sections C.2 through C.5. Determine how you will boot the installation program, and issue the boot command that will start the installation.]

3.2.1 Booting the Installation Program

Booting the Installation Program

To start installing Red Hat Linux, insert your boot diskette into your computer's first diskette drive and reboot. After a short delay, a screen containing the boot: prompt should appear. The screen contains information on a variety of boot options. Each boot option also has one or more help screens associated with it. To access a given help screen, press the appropriate function key as listed in the line at the bottom of the screen. You should keep two things in mind:

Normally, you'll only need to press [Enter] to boot. Watch the boot messages to see whether the Linux kernel detects your hardware. If it does not properly detect your hardware, you may need to restart the installation in ``expert'' mode. Expert mode disables most hardware probing, and gives you the option of entering options for the drivers loaded during the installation. Expert mode can be entered using the following boot command:

boot: expert

Please Note: The initial boot messages will not contain any references to SCSI or network cards. These devices are supported by modules that are loaded during the installation process.

Options can also be passed to the kernel. For example, to instruct the kernel to use all the RAM in a 128 MB system, enter:

boot: linux mem=128M

After entering any options, press [Enter] to boot using those options. If you do need to specify boot options to identify your hardware, please make note of them -- they will be needed later.

[Intel Systems:

3.2.1.0.1 Installing Without Using a Boot Diskette
Installing Without Using a Boot Diskette

Alternatively, if you have MS-DOS installed on your computer, you can boot the installation system directly from the CD without using any diskettes.]

To do this, use the following commands (assuming your CD is drive d:):


C:\> d:
D:\> cd \dosutils
D:\dosutils> autoboot.bat

Note that this method will not work if run in a DOS window -- the autoboot.bat file must be executed with DOS as the only operating system. In other words, Windows cannot be running.

Please Note: The Red Hat Linux/Intel CD-ROM can also be booted by newer computers that support bootable CD-ROMs. Not all computers support this feature, so if yours can't boot from CD-ROM, you'll have to use a boot diskette (or autoboot from DOS) to get things started.


Next Up Previous Contents Index