Previous | Contents | Index | Next
2.2.17.2 Disconnect Joint
Disconnecting a joint between two pieces of connected track;
- 
Click the Split button ( ) to activate the Split command. ) to activate the Split command.
- 
Place the mouse pointer right over the joint between the two track endpoints (so the "X" is shown) then Left-Click.
- 
A blue marker will show where a split will occur, but if the cursor is a near connected joint, it will show a blue "X".
 
- 
When the Split command completes, the joint at the two track endpoints will show three lines rather than one. The three lines represent abutted, disconnected track endpoints.
- 
  
- 
Joint prior to split
- 
  
- 
Joint following split
For detail about;
- 
Dividing a section of track into two connected pieces see Section 2.2.17.2.1.
- 
Creating block gaps at an existing joint see Section 2.2.17.2.2.